![]() The command will also list any processes that might cause issues later on during this guide.If your network adapter supports Monitor Mode then you should see (monitor mode enabled) at the bottom of the screen.If your adapter is under a different name simply substitute the name where wlan0 is shown.Enter the command sudo airmon-ng start wlan0.However, if you have multiple adapters it may be listed as a different name. If your operating system recognizes your adapter, then you should see wlan0 under the lo section. This will show all your networking interfaces connected to your device. However, if you have multiple adapters it may be listed as a different name.Įnter the command ifconfig. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |